Differences

This shows you the differences between two versions of the page.

--- oxygen:consoleport [2022/08/24 19:28] – [Trenz Electronics XMOD FTDI JTAG Adapter TE790-03] gflynn
+++ oxygen:consoleport [2022/09/29 10:08] (current) – [Connecting a SparkFun Serial Basic Breakout –CH340C and USB-C, DEV-15096] tcarpenter
@@ Line 24: / Line 24: @@
 ====Serial UART Connections====
 The Oxygen UART uses a 3.3V connection operating at 115200 baud rate:
-Pin 1 is the pin closest to the edge of the case, farthest from the "GPS" label
+Pin 1 is the pin closest to the edge of the case, farthest from the "GPS" label.
 The pinout for the serial UART connection on the RWT Oxygen SDR is:
@@ Line 37: / Line 37: @@
-Oxygen Pin 1 – Oxygen Ground to Adapter Ground
+  * Oxygen Pin 1 – Oxygen Ground to Adapter Ground
-Oxygen Pin 3 – Oxygen TX Output to Adapter RX Input
+  * Oxygen Pin 3 – Oxygen TX Output to Adapter RX Input
-Oxygen Pin 5 – No connection, skip it
+  * Oxygen Pin 5 – No connection, skip it
-Oxygen Pin 7 – Oxygen RX Input to Adapter TX Output
+  * Oxygen Pin 7 – Oxygen RX Input to Adapter TX Output
 {{ oxygen:oxygenhookupwithusbmicromodule.jpg?nolink&400 |}}
@@ Line 53: / Line 53: @@
 This module provides serial to USB 2.0 conversion utilizing a USB-C port to connect the Oxygen unit boot terminal to a host computer. Connections are as follows:
-Oxygen Pin 1 – Oxygen Ground to Adapter Ground
+  * Oxygen Pin 1 – Oxygen Ground to Adapter Ground
-Oxygen Pin 3 – Oxygen TX Output to Adapter RX Input
+  * Oxygen Pin 3 – Oxygen TX Output to Adapter RX Input
-Oxygen Pin 5 – No connection, skip it
+  * Oxygen Pin 5 – No connection, skip it
-Oxygen Pin 7 – Oxygen RX Input to Adapter TX Output
+  * Oxygen Pin 7 – Oxygen RX Input to Adapter TX Output
 {{ oxygen:oxygenhookupwithusbcmodule.jpg?nolink&400 |}}